The EVO MFG 6.5” Jeep Gladiator JT Enforcer Suspension
Systems lift your 2020+ Jeep Gladiator JT 6.5”s. The JT Enforcer kits are
specifically designed and engineered to lift your JT and maintain a performance
spring rate, smooth ride quality all while retaining tow capacities. These kits
allow for use of your choice of any aftermarket 6” lift shock or use of our EVO
SPEC tuned 2.5” Remote Reservoir King Shocks. These kits come with a set of
4.5” lift springs specific to each corner which will keep the Jeep Gladiator JT
level side to side. The difference with EVO MFG Enforcer Overland systems vs
EVO MFG Enforcer systems is the use of front Overland Control Arm
When lifting your vehicle your control arms at ride height
have a steeper angle towards the floor which can have some negative effect/chop
in ride quality. With the use of the included Overland Control Arm
brackets we relocate the front control arm mounting locations at the frame.
In doing this when lifted we maintain factory flatter control arm angles and
while minimal, we alleviate much of the chop associated with lifting a Jeep
giving even better and more improved ride quality. Also, in the use of
Overland Drop Brackets we can engineer more performance into the front
suspension to improve braking and driveline angles through suspension
Both kits drive very well, the Overland Kits are better
suited for less hard off-road crawling and more light off road and on road use.
The EVO MFG 6.5" JT Enforcer Kits are easy to install using normal tools.
No drilling or cutting. They require no exhaust modifications.
Simple Bolt on installation. EVO MFG JT Enforcer kits are available in
multiple configurations to suit your needs and budget and are upgradable down
the road. All included Enforcer Arms use only rebuildable free
articulating spherical bearings on all ends of each arm giving restriction free
travel and articulation. The included Enforcer arms are manufactured from
large diameter, thick wall DOM Steel Tubing for ultimate in strength and
longevity both on and off the trail. These kits require wheel spacers or
aftermarket wheels with smaller backspacing and aftermarket front
driveshaft. Front and rear adjustable track bars to fine tune axle center
are included with PLUS “P” kits. “K” Kits include a set of 4 EVO SPEC
Remote Reservoir King Shocks.
*FOR 4.5"/6.5" JT Lifts: Front Lower and Rear
Upper Adjustable Control Arms and Front & Rear Adjustable Track bars are
required for proper alignment/install. These components are included with
Stage 3 and Stage 4 "PLUS" Kits.
Note: 6.5" Gladiator kits require an
aftermarket front driveshaft. Rear aftermarket driveshaft is recommended.