1. Home
  2. Exterior
  3. Bumpers
  4. Front Bumpers
  5. Motobilt Crusher Series Front Bumper w/ Grill Hoop And Stinger - Bare Steel - JK

Motobilt Crusher Series Front Bumper w/ Grill Hoop And Stinger - Bare Steel - JK

Write a Review
Your Price: $976.00
Part Number: MB1011-L
Free Shipping on orders over $70

The Motobilt Crusher recessed winch bumper with grill hoop and stinger will provide you the ultimate in protection and recovery. The bumper allows you to secure your winch down low in between the frame rails. The grill hoop, stinger, and connecting tubes are made from 1.75-inch x .120-inch wall DOM tube. The high clearance design includes a built-in skid plate also. The bumper is made from 3/16-inch-thick steel plate that is laser cut at Motobilt HQ then cnc bent. The bumper uses 3/4-inch-thick laser cut d-ring mounts that pass through the bumper and are welded both inside and out. This setup provides for superior strength.

Features

  • Winch Ready
  • Measures in at just 46.5 inch at its widest point
  • 3/16-inch-thick steel plate
  • 3/4-inch-thick laser cut d-ring mounts that pass through the bumper and are welded both inside and out
  • Connecting tubes are made from 1.75-inch x .120-inch wall DOM tube
  • Includes all the necessary mounting hardware
  • Sold as kit

Note:

  • Will Not work with Teraflex S/T Dual rate front sway bar
  • The outer edge of the crash bar will need to be trimmed to fit where the lower portion of the bumper mounts
  • The 8 factory mounting holes may need to be open up to a 9/16".
  • Ships bare metal and will need to be painted or powder coated once you receive it
  • You must fully installBEFOREpainting and then removed for paint or powder coating.
  • 2012 and newer models will need a vacuum relocation pump. PN MB2060
  • Fairlead spacer included to allow use of a centered or off set winch design.
  • Does NOT work with Super Winch EXP

Recently Viewed Items

TOP